150 Series
— CompX refrigerator eLock Instructions
2
What’s needed?
w
6 – premium brand AA alkaline batteries
w
Drill
w
#
2 philips head bit
w
T15 pin-in Torx (6-lobe) bit or driver (secures battery
compartment and strike plate cover screws)
w
Rubbing alcohol
w
Level
Care and Cleaning
The eLock is a battery operated device. Therefore, it should
be part of a regular battery maintenance program.
To clean the surface of the eLock controller, apply non-acid
based cleaner to a clean cotton cloth; do not spray cleaner
directly on the controller. Wipe down keypad and housing
taking care around the USB and edges of keypads. Wipe
excess cleaner off of all surfaces.
Setting up the eLock
Install 6 AA alkaline batteries. (not included).
Warning: install the batteries as shown in the battery
compartment. Polarity (+) or (-) must be correct. Replace
batteries as a set. Always use new batteries when replacing
the old set. Do not combine a used battery with a new one.
Only use premium alkaline batteries; do not mix battery
types.
GETTING STARTED
The eLock is shipped with no PIN or if equipped card
credentials.
There are 2 levels of credential: User / Supervisor.
Only a Supervisor credential(s) is allowed to manually
program
Note: Green LED on reader will flash upon presenting a valid
Supervisor level credential, versus a solid green LED upon
presenting a User level credential
INITIAL PROGRAMMING OUT OF THE BOX or AFTER A
FACTORY RESET HAS BEEN PERFORMED
(
See page 3 for FACTORY RESET instructions
)
1. Press and hold “ENTER” until the beeping stops
2. Enter PIN (4 to 14 digits) and press “ENTER” or present card
(if equipped)
This PIN / card is now a Supervisor level credential occupying
slot 001
The maximum number of slots per eLock is 250
TO ADD A USER
1. Input a valid Supervisor PIN and press “ENTER” or present
valid Supervisor card
2. Press and hold “ENTER” until beeping stops
3. Input the new User PIN and press “ENTER” or present new
User card
TO ADD A SUPERVISOR
1. Input a valid Supervisor PIN and press “ENTER” or present
valid Supervisor card
2. Press and hold “ENTER” until beeping stops
3. Press and hold “ENTER” again until beeping stops
4. Input new Supervisor PIN and press “ENTER” or present NEW
Supervisor card
TO DELETE A USER OR SUPERVISOR
1. Input a valid Supervisor PIN and press “ENTER” or present
valid Supervisor card
2. Press and hold “CLEAR” until beeping stops
3. Input the PIN to be deleted and press “ENTER” or present
existing card to be deleted
TO ADD A USER WITH A SPECIFIC SLOT
ASSIGNMENT
1. Input a valid Supervisor PIN and press “ENTER” or present
valid Supervisor card
2. Press and hold “ENTER” until beeping stops
3. Enter slot number that will be assigned to user and press
(Example: to program slot 18 type 018)
4. Input the new PIN (4 digit min) and press “ENTER” or present
NEW card
150 Series
Refrigerator eLock — Programming
