- 11 -
Cut or break out the outlets to the required connection points at the
bottom of the receiver unit, in order to be able to connect wires to them.
ATTENTION!
When the two units of the thermostat can only be located on
or outside the boundary of the range due to the layout of the building or the
shielding effect of the building structures between the units then, in order
to guarantee reliable RF connection, please install a
COMPUTHERM
Q2RF
type RF transmitter between the two units.
7.2 Putting the receiving unit into operation
Turn on the power supply to the receiver unit. A few seconds after the
LED lights flash once, the receiver unit becomes ready for operation. This
state is indicated by the blue LED light with the "
A/M
" sign. After this, you
can start tuning the receiver and the thermostats together. Following this,
you can start synchronization of the thermostats and the receiving unit
according to the following steps:
Receiving unit:
• Press and hold the button which belongs to the zone with which you wish
to synchronize thermostat
OMPUTHERM
Q5RF
until the red LED beside
the button starts to flash.
Thermostat:
• Separate the back panel of thermostat
OMPUTHERM
Q5RF
from the
front panel by pushing the latch located on the upper side of the case.
• Press and hold buttons „
LEARN
” and „
RESET
” located inside the ther-
mostat smultaneously.
• Release the „
RESET
” button and keep the „
LEARN
” button depressed
for additional 5 seconds.
• Following this, sign
U1
appears on the display of the thermostat, indi-
cating that the thermostat can now be synchronized with zone 1 of the
receiving unit.
• With the help of
and
buttons select the zone from 1 to 4 with
which you wish to synchronize the thermostat.
• Press and hold the „
LEARN
” button located inside the thermostat for
approx. 3 seconds until on the receiving unit of
COMPUTHERM
Q5RF/
Q8RF
the LED belonging to the zone concerned stops flashing.
- 11 -
Summary of Contents for Q5RF
Page 2: ......
