Assembling the White PCB Kit with 18 LEDs
Please verify that your kit contains the following parts:
1.
6 – 150
Ω
¼
W resistors
2.
18 – 5mm white LEDs
3.
1 – White MR-16 PCB
Assemble and solder these parts in the following order (refer to PCB outline above):
3 – 1cm lengths from the resistor leads and solder across J1, J2, and J3.
6 – 150
Ω
LED resistors where the Red, Blue, and Green (Grn) resistors are located.
18 – 5mm white LEDs as marked (
Important: notch goes to the left as shown
).
Connect one ground wire to either the Red (R), Green (G) or Blue (B) LED ground point as marked.
Connect one wire to the LED +12V common (C) power supply as marked.
Assembling the PCB with 9 LEDs
Please purchase the following parts:
1.
3 – Suitably-valued
¼
W resistors (1.70mm x 3.20mm size, through-hole)
2.
9 – 5mm or Piranha LEDs (your choice but keep similar colours in one set)
3.
1 – RGB MR-16 PCB
Assemble and solder these parts in the following order within the
Nine LED
area (refer to PCB outline above):
3 – LED resistors where the Red 1, Blue 1, and Green 1 resistors are located
9 – 5mm LEDs as marked in the
Nine LED
area (
Important: notch goes to the left as shown
)
Connect three wires to Red, Green and Blue LED ground points as marked
Connect one wire to the LED +12V common power supply as marked
C o m p u t e r I n s p i r a t i o n s
!
A s s e m b l y & Te c h n i c a l M a n u a l
3