Assembling the RGB PCB Kit with 18 LEDs
Please verify that your kit contains the following parts:
1.
2 – 300
Ω
¼
W resistors
2.
2 – 150
Ω
¼
W resistors
3.
2 – 120
Ω
¼
W resistors
4.
6 – 5mm red LEDs
5.
6 – 5mm green LEDs
6.
6 – 5mm blue LEDs
7.
1 – RGB MR-16 PCB
Assemble and solder these parts in the following order (refer to PCB outline below):
Cut a 1cm length from one of the resistor leads and solder across J3.
2 – 300
Ω
LED resistors where the Red resistors are located.
2 – 150
Ω
LED resistors where the Blue resistors are located.
2 – 120
Ω
LED resistors where the Green (Grn) resistors are located.
6 – 5mm red LEDs as marked (
Important: notch goes to the left as shown
).
6 – 5mm blue LEDs as marked (
Important: notch goes to the left as shown
).
6 – 5mm green LEDs as marked (
Important: notch goes to the left as shown
).
Connect three wires to Red (R), Green (G) and Blue (B) ground points as marked.
Connect one wire to the LED +12V common power supply as marked.
C o m p u t e r I n s p i r a t i o n s
!
A s s e m b l y & Te c h n i c a l M a n u a l
2
Red Resistor 1
Red Resistor 2
Blue Resistor 2
Blue Resistor 1
Green Resistor 1
Green Resistor 2
Install Jumper
Nine LED installation
+12V Common
Blue Ground
Red Ground
Green Ground