background image

We have pre-fabricated two different pages of gauges that you can toggle between by swiping left or 
right. Now that the Pro Dash has learned your sensors, you can touch and hold on a gauge, select Edit 
Gauge, and select a different sensor from the Gauge Sensor dropdown list. You can also change, the 
size, gauge type, refresh rate and min and max range of the gauge. If you don't like the gauge there, you
can easily delete it or move it. You can also create a new page by touching and holding anywhere on 
the screen, select More Options and then Add New Page. There are infinite options for customization 
and more options and features will likely be added in the future.

Dash Won't Turn On

When you turn on power after not using for more than 4 hours, the dash will take up to 60-90 seconds 
before your screen displays the gauges. If nothing shows up on your screen at all then disconnect the 
Detusch connector, wait 2 minutes and then plug back into power. 
Leave powered for a minimum of 10 minutes to give a completely dead battery time to charge enough 
to run. If after that 10 minutes, you see no activity on the screen at all, use a paperclip or small allen 
wrench and push and hold the reset button for 10 seconds on the side below the usb port. 
If that fails to turn the screen on at all, use a volt meter to ensure the Black and red pin on the car 
wiring side of the Detusch connector has 12v. Black should be pin 1 and Red should be pin 3. If you do
not have 12 volts, you need to clean up the wiring between the main and lcd. 
If you do have 12 volts, it is possible that your internal dash battery is dead. Leave 12v on for a 
minimum of 30 minutes, then remove power for 1 minute and plug back in. This should cause the unit 
to go into the slow boot and display the gauges within 1-2 minutes. 

DataMaxx Pro Dash Instructions – Page 8

Summary of Contents for DataMaxx Pro Dash 8









Reviews: