136
Messages Indication
Solution
BUFFER OVERFLOW
CHARACTER LOST
A buffer overflow condition
occurred (for the serial
interface).
Turn the printer off and on again, or press
the
PROGRAM
and
ON LINE
key successively
to clear the buffer.
DATA SET OFF
The DSR Signal is not
connected to the printer
and is not ready for data
transfer (if the serial
interface is selected). This
condition may happen in a
remote connection (via
modem) and the DSR
(DATA SET READY)
signal is missing.
Press the
ON LINE
key to reset the error
condition.
INTERLOCK ERROR
CHECK INSERTION
The rear plug cover is not
installed on the printer.
Install the rear plug cover on the printer.
JAM FRONT1 PATH
CHECK PAPER
A paper jam error
condition occurred in the
Front1 paper path.
Check the paper path and remove the
jammed paper. Press the
ON LINE
key to reset
the error condition.
JAM FRONT2 PATH
CHECK PAPER
A paper jam error
condition occurred in the
Front2 paper path.
Check the paper path and remove the
jammed paper. Press the
ON LINE
key to reset
the error condition.
NO PATH AVAILABLE
An electromechanical
failure occurs in the paper
paths.
Call Service.
Summary of Contents for 9300e
