113
A
A
d
d
j
j
u
u
s
s
t
t
i
i
n
n
g
g
t
t
h
h
e
e
T
T
e
e
a
a
r
r
-
-
O
O
f
f
f
f
P
P
o
o
s
s
i
i
t
t
i
i
o
o
n
n
To check the Tear-Off Position, proceed as follows:
1.
Check if the paper perforation matches the tear-off bar on the printer.
2.
To move manually the paper to the Tear-Off position, press the
TEAR
key when the printer is
enabled without printing (
TEAR NORMAL
function selected
YES
in the
Program Setup
).
You can leave the manual tear off function by pressing again the
TEAR
key.
If it does not:
1.
Turn the printer off and press the
PROGRAM
key and hold it pressed while powering on the printer
until the
RELEASE KEYS
message is displayed to enter the
Power-On Configuration
.
2.
Press the
↓
key until the following message appears:
FUNCTIONS
3.
Press the
→
key to enter and then press the
↓
until the following message is displayed:
TEAR ADJUST xxx
4.
Press the
→
or
←
key to scroll the values of this function.
The values below 0 move the tear-off position downwards, values above 0 move the paper
upwards. The values can be set between -390 and +30 at 1/180 inches (from -13/6 to +1/6 inches).
5.
When the desired value is displayed, press the
PROGRAM
key.
6.
Press the
PROGRAM
key to save and exit from the setup.
Summary of Contents for 9300e
