HaYetsira St. 17, Yokneam, Israel
Tel
:
+972-48-290-168
Fax
:
+972-48-325-251
www.airtop-pc.com
www.airtop-pc.com
Page
21
of
25
Airtop owner’s manual
Servicing Airtop
Safety instructions
Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your
personal safety. Unless otherwise noted, each procedure included in this document assumes that the following
conditions exist:
You have read the safety information that shipped with your computer.
A component can be replaced or, if purchased separately, installed by performing the removal procedure in
reverse order.
WARNING: Disconnect all power sources before opening the computer cover or panels. After you finish working
inside the computer, replace all covers, panels, and screws before connecting to the power source.
WARNING: Before working inside your computer, read the safety information that shipped with your computer.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Compulab is not covered
by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically
touching an unpainted metal surface, such as a connector on the back of the computer.
CAUTION: Handle components and cards with care. Do not touch the components or contacts on a card. Hold a
card by its edges or by its metal mounting bracket. Hold a component such as a processor by its edges, not by its
pins.
CAUTION: When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables
have connectors with locking tabs; if you are disconnecting this type of cable, press in on the locking tabs before
you disconnect the cable. As you pull connectors apart, keep them evenly aligned to avoid bending any connector
pins. Also, before you connect a cable, ensure that both connectors are correctly oriented and aligned.
Before servicing Airtop
To avoid damaging Airtop, perform the following steps before you begin working inside the computer.
1.
Ensure that you follow the Safety instructions.
2.
Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.
3.
Turn off your computer, see Turning off Airtop.
CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable
from the network device.
4.
Disconnect all the network cables from the computer. Disconnect your computer and all attached devices from
the electrical outlets.
5.
Press and hold the power button while the computer is unplugged to ground the system board.
6.
Open Airtop’s Clamshell door.
Summary of Contents for Airtop
Page 1: ...Owner s Manual ...