Stereo Effect
Stereo Effect is a function that will simulate stereo sound when your audio
input is Mono. When your audio input is stereo, it will enhance the effect and
give you a greater feeling of the surrounding effect. To activate this function,
please press the
MENU
button and select
Sound
section, then adjust the
volume
of
Stereo Effect
higher for greater effect. You may refer to the
OSD
Menu Guide
above for exact location.
SAP Mode
(Only appears in PAL/SECAM TV system area)
SAP Mode is a function that will allow you to broadcast Main Audio Channel in
the left and Sub Audio Channel in the right. To activate this function, please
press the
MENU
button and select
Sound
section, then select
ON
with the
option of
SAP Mode
. Switch to the channel that contains both Main and Sub
Audio Channel, and then change the stereo mode to SAP by pressing
SAP
button on the remote controller.
Troubleshooting
Installation
The most common cause of the problem is the incorrect connection of the
cables. Please refer to “VideoMate V200/V200F TV Box Connection” on
proper connection. And also please check the power adaptor already plugged.
Warning
It is normal for VideoMate V200/V200F TV box become warm when it is being
used. Please place the TV Box at a place where the air flows.
Please do not use other adaptor except the one included in the package to
prevent damaging V200/V200F. Damaged V200/V200F by using wrong
adaptor will not be cover from the warranty.
No Picture
Please make sure you have properly connected the TV cable to TV Box in
order to watch live TV. It might also because the input source of V200/V200F
TV Box is not set to TV mode, please switch the video input source to TV.
