Page 6
INSTALLATION INSTRUCTIONS
COMPOSE AGFA PCI I/F CARD
xvi.
After configuring both the
PCI Card Driver Options and the Plugin Options, you should
click on the OK button in the Install Agfa Driver menu to install the driver. You will then
see the following messages indicating that the drivers have been copied to the hard drive.
•
If the Agfa card is inserted and configured properly. You will see the message:
The interrupt type is ISA if the ISA paddle card is used. If the ISA paddle card is not used,
the interrupt type will be PCI (Level trigger).
•
If the Agfa card is not configured properly and the install program cannot find a suitable
Interrupt to assign to the Agfa Card, the installation program will indicate that the
Interrupt routed to is not found.
Please read the next section for a guideline on PCI Configuration for your PC.
•
If the card is not inserted properly, you will see the following message cannot scan Agfa
PCI Card..
scan pci card and set interrupt.
cannot scan Agfa PCI card!
scan pci card and set interrupt.
Video card....................found.
CGEN/APIS-PCI ver 1.2.
Serial number.................96120002.
PCI cfg space control.........Plug and Play feature enabled.
PCI cfg int setting...........INTA, IRQ 14.
Interrupt routed to...........not found.
scan pci card and set interrupt.
Video card....................found.
CGEN/APIS-PCI ver 1.2.
Serial number.................96120002.
PCI cfg space control.........Plug and Play feature enabled.
PCI cfg int setting...........INTA, IRQ 14.
Interrupt routed to...........IRQ 10.
Interrupt type................ISA type (edge trigger).
Copy A:\AGFA\agfapci.I32
to c:\express\SW\DEVICES\agfapci.I32.
Copy A:\AGFA\CSLAGFA.SYS
to C:\WINNT35\System32\drivers\CSLAGFA.SYS.
