34
Compool Cp3810
The P key turns on the
Filter Pump.
Keys 1-6 activate auxiliary
equipment.
Activates the Heater and Solar.
3 - Hour Filter Override
It is possible to override the daily equipment operating cycles, and manually activate (or
deactivate) the filter pump and any of the 6 auxiliary circuits for a 3-Hour period. This is
particularly useful when adding chemicals to the pool.
Note The Control System must be in “Auto” mode to enable these feature.
To turn the filter pump on, press the P key (Filter Pump) 2 times quickly. The “Auto” mode
Status Lamp will begin to blink, and the Filter Pump Status Lamp will illuminate for the 3-Hour
cycle.
To turn the filter pump off, press the P key (Filter Pump) 3 times quickly. The “Auto” mode
Status Lamp will begin to blink, and the Filter Pump Status Lamp will not be illuminated during
the 3-Hour cycle.
Sensor Status
If there is a fault with a temperature sensor, the appropriate status lamp will turn on. Check
cable and connections to appropriate sensor. If necessary, replace Temperature Sensor.
Spa-side Remote
The Spa-side Remote allows controlling your equipment from the spa. The light in the middle
of the switch will turn on whenever the spa is on. The light will blink when the spa is being
heated.
Spa-side Heat Boost
If your Spa-side Remote has one of its buttons designated for the controlling the Heat Boost
feature, it is possible to manually activate the heater, and boost the spa temperature for a five
minute period. This feature can only be activated if the Spa-side Remote light is not blinking.
