13
Compool Cp3810
Low Voltage Cables
Control Panel
6-conductor cable runs between the Control Panel and the Power Center.
Heater Connection
2-conductor cable runs between the heater and the Power Center.
Water Temperature Sensor
2-conductor cable runs between the Water Temperature Sensor and the Power Center.
Freeze Temperature Sensor
2-conductor runs between the Freeze Temperature Sensor and the Power Center.
Caution Do not install low voltage and high voltage wires in the same conduit. Use conduit
when cable goes underground.
Gas Heater Connections
The diagram above shows how to wire a gas heater.
•
To wire the gas heater
1.
Run a 2-conductor cable from the heater to the Power Center.
2.
At the heater, connect 2-conductor cable as instructed in heater installation manual.
3.
At the Power Center circuit board, connect 2-conductor cable to the HTR terminals.
4.
If heater has electronic ignition, provide high voltage power from the Sub-panel.
HEATER
CONTROL
GAS VALVE
PRESSURE
THERMOSTAT
LIMIT
OFF
ON