Installation Instructions
MT Turning Bar and Fire Pole Add on
MT Fire Pole
Turning Bar
(Approximately one 80 lb.
bag of concrete mix)
• Determine Desired Location of Fire Pole on the Top Rail, or the
Turning Bar on the Upright Ladder Leg.
• Determine location of hole and dig hole as shown below.
• Clamp Fire Pole or Turning Bar into position, level and cement in
ground.
Turning Bar / Fire Pole
Turning Bar
Tighten
until clamps
are snug
against rail
Fire Pole or
Turning Bar
3/8” Nyloc
Nut
Top Rail or
Ladder Leg
2 3/8” Clamp
3/8 x 1 ½” Bolt
1 5/8” x 48”
Cross Piece
72” Upright
2 7/8” x 3” Sleeve
Set Screw
Set Screw
Set Screw
