Summary of Instructions
1.
Select an area in your yard that is reasonably level and meets the
space requirements for your equipment. Ground Space: 9’ x 13’ Play
Space: 13’ x 29’
2.
Using the measurements from the top view diagram, measure and
mark the position of the Swing Hangers and Upright Ladders on both
9’ Top Rails. Place the Horizontal Ladder on the ground in the
desired location with Top Rails in the correct position on the ground.
(Measure and adjust the Horizontal Ladder on the ground as
necessary to provide for the proper play space.)
3.
Move the 9’ Top Rails and set aside.
4.
With the Horizontal Ladder in its proper position, mark the locations
for the holes where the two Upright Ladders will stand.
5.
Move the Horizontal Ladder and dig the holes (see hole sizes for
cementing).
6.
Lay each Upright Ladder on the ground near the hole where it will
eventually stand. Make a mark 15” from the top of the Ladder onto
each Ladder Rail.
7.
Move the Adjustable Sleeves to these marks and position them to
receive the Horizontal Ladder. This is accomplished by turning them
to point at a 90 degree angle toward what will become the inside of
the structure. (The rungs are welded to what will become the outside
of the structure.) Secure set screws.
8.
Repeat the process on the other Upright Ladder. Secure set screws.
9.
Place the Upright Ladders onto their sides with the bottom of the pipe
just over the hole where it will eventually stand. Attach the Horizontal
Ladder to the Adjustable Sleeves of the Upright Ladders and secure
the set screws (see Horizontal Ladder to Upright Ladder assembly).
Hint: Do not push Horizontal Ladder tight against the Upright
Ladders. Leave a ½” - 1” gap between the Upright Ladder Rails and
the Horizontal Ladder. This will allow for easier adjustment of the
Summary of Contents for HL50
Page 4: ......
