Compcooler, keep your body cool and comfortable in harsh conditions.
10
Trouble shoot and Fault Code
Item
Code
Description
1
E1
Wrong Polarity or reverse connection from power input
2
E2
Low voltage protection, less than 18V
3
E3
High voltage protection, more than 32V
4
P1
No liquid temp signal from sensor
Cautions:
1.
Please confirm chiller voltage is 110V or 220V before connect AC power.
2.
Please make sure battery output 20A for DC operation, or 400W for vehicle operation.
3.
Please do not turn ON/OFF to run to stops system frequently within a short period, it may
affect the refrigeration system, and significant enhance power consumption.
4.
Please do not block air inlet and outlet, it may cause the problem of compressor overheat or
less cooling capacity.
5.
Please make sure cooling garments or vest be connected before start pump circulation, it may
cause unit leak because of pump pressure.
6.
Please use anti-freeze liquid if temperature setting lower than 0
℃
7.
Please do not run the system close to fire or under water.
8.
Max operation temp is 60
℃
, unit could be overheated protection in hot ambient.
9.
Please stop operation and disconnect the power if high vibration or abnormal noise.
Safety:
It is important to become thoroughly familiar with the manual and operating characteristics of the
unit. It is the owner’s responsibility to assure proper operator training, installation, operation and
maintenance of the unit. Observe all warning can result in injury to the operator and severe
mechanical damage to the unit.
Warranty:
Compcooler Warrants to the original Purchaser that products sold shall be free from defects
material and workmanship for warranty period not exceed one year from the date of shipment.
Compcooler agrees to correct for the original user of this product, either by repair, or at the
manufacturer’s election by replacement. This warranty shall not apply if the defect or malfunction
was caused by accident, neglect, unreasonable use, improper service, or other causes not arising
out of defects in material or
workmanship. The manufacturer’s sole obligation under this warranty
is limited to the repair or replacement of a defective product and shall not in any event be liable
for any incidental or consequential damages of any kind resulting from use or possession of this
product.
