AO1 / AO2 / AO
2
PolyPanel
ls
9
Panel Height Change
At a Connector
Note: Wherever your furniture plan calls for transaction counters mounted to panels, please
review the section “Transaction Counter Installation” before connecting the panels beneath.
Follow the instructions below for changing the connector wedge block position on any 2-way 90
˚
, 2-way
180
˚
, 3-way or 4-way connector to attach a panel of lower height.
1. Lay connector on a flat, protective surface.
2. Remove connector Top Draw Block(s) to reveal top cap release port.
3. With a screwdriver, press both top cap extension tabs, as shown at right, while pulling on top cap
to release it.
4. Remove connector wedge block (Top Draw Block and Top Wedge Block) by removing both
wedge block screws. Remove the threaded nut plate that has dropped after removing the screws
by tipping the connector so that it slides out either end.
5. Remove connector filler strip from the side to be adjusted; remove from bottom end first by prying
or pulling end away. Filler strip is held in place with double-faced adhesive tape.
6. Install wedge block and threaded nut plate removed from top location to new height desired.
•
Begin by threading a screw into the threaded nut plate, making sure the raised ridge
around threads faces screw head; this helps to properly locate the threaded plate.
•
Position one end of the threaded plate, as shown, through the access hole above the
wedge block screw holes into place. While holding its position, place wedge block into
place. Insert screw through wedge block and connector; do not tighten completely.
•
Remove wedge block screw used to position threaded nut plate. Use inserted screw to
align nut plate into position. You may
need to tighten or loosen the screw
for better positioning control and/or
hold connector for gravity to position
nut plate. Once in place, finger-start a
screw through the wedge block and
connector into the nut plate.
Note: the hole in the adjacent or opposite side of
the connector can be used to insert a screwdriver
to hold the threaded nut plate in position for
installing wedge block screws.
7. Cut filler strip at bottom end and install to fit between top and bottom wedge blocks.
8. Reattach the top draw block to the connector wedge block and replace top cap.
Threaded Nut Plate
-
20 x
”
Pan Head Screw
Top Wedge
Block Screws