AO1 / AO2 / AO
2
PolyPanel
ls
3
Introduction
These instructions provide the necessary information to safely install Compatico’s following products:
•
AO1
•
AO2
•
AO
2
PolyPanel
AO1/AO2/AO
2
PolyPanel is a time-tested office partition furniture system that includes a
comprehensive vocabulary of panels, power/cabling management, work and storage
components as well as accessories. These products also offer the distinction of family of
modular furniture designed to provide a broad range of solutions for both open plan and private
office requirements.
AO1/AO2/
AO
2
PolyPanel is designed to provide inordinate flexibility and
cost savings with the added ability to route, manage and store cables in accordance with the
latest telecommunications industry standards.
The characteristics of the system require panel arrangements and panel supports as outlined in this
manual for a safe and secure installation. Rearrangements and additions to an installation must to
the same stability and installation guidelines to ensure continued safe use. Compatico shall not be
liable for product that is used or altered in any other way.
WARNING: Failure to follow these instructions can result in personal injury or product damage or
both.
Tools Required
Many products are shipped assembled at the factory and need only to be installed. Some
products are shipped in subassemblies requiring field assembly during installation. The
following are tools necessary to properly install Compatico
AO1/
AO
2/AO2 PolyPanel
products.
•
” Allen Wrench
•
#2 and #3 Philips Screwdriver/bits
•
25’ – 30’ Tape Measure
•
Plastic/Rubber
Mallet
•
Slotted
Screwdriver
•
6” long Philips Extension Bit (for pencil drawer bearers)
•
9”-long or longer Magnetic ‘Torpedo’ Level
•
Utility Razor Knife
The following tools will speed-up larger installations or be handy in special circumstances.
•
12v – 18v Drill/Driver (with spare batteries and charger)
•
Set of Drill Bits & Screw Bits
•
” Ratchet Allen Wrench
•
Chalk Line and/or 2” Masking Tape (to locate/mark panel run starts)
•
4’ Carpenter’s Bubble Level
•
Hack Saw or Power Reciprocating Saw with Metal Blades
•
Hammer
•
Pliers
•
250-lb capacity Wonder™ Bar (pry bar)
•
Aviator/Tin Snips (yellow handle)
•
Continuity/Electrical
Tester
•
Panel Skates (for 10 work stations or more)
•
Dollies & Panel Carts (for 10 work stations or more)
•
Laser Leveler Device (for 10 work stations or more)