24
Chapter 6 - Basic Configuration Guide
Suggested for IPX
If you plan to use dial-on-demand for this link, you should set the
update method to “triggered” to avoid the link being brought up by
transmission of IPX RIP information. You should only use triggered
operation when you are connecting to another Compatible Systems
router at the other end.
When you set up an on-demand link with IPX, you should carefully
monitor link usage to determine whether the link is being activated only
when it is needed. Additional router configuration will be required for
many networks in order to achieve optimal link usage.
•
Set update method
CV: Use the IPX Routing: WAN Dialog Box.
TB: Use configure and set the Updates keyword in the IPX WAN 0
(and/or WAN 1) section.
Frame Relay Configuration
This section covers the settings required for Frame Relay operation of
the MicroRouter 1220i WAN interfaces. In general, the parameters
listed here should be set for each WAN interface on which you plan to
use Frame Relay.
Link Configuration
Frame Relay is presently supported in the MicroRouter 1220i only via
dedicated line operation.
•
Set Dedicated connection
•
Set Frame Relay connection
CV: Use the Link Configuration: WAN Dialog Box.
TB: Use configure to set the Mode and ConnectMode keywords in
the Link Config WAN 0 (and/or WAN 1) section.
Suggested for Dedicated/Leased Line Operation
Dedicated line operation generally does not require additional parame-
ters for operation.
Frame Relay DLCI Mappings
If you are connecting to another Compatible Systems router, this infor-
mation is not required for Frame Relay operation. Compatible Systems
