Chapter 6 - Basic Configuration Guide
27
IPX Protocol
Required for IPX
Frame Relay operation requires that the WAN interface is set to be a
“numbered interface.” This means that the interface (and thus the
Frame Relay network) must have an IPX network number.
•
IPX numbered interface
•
IPX Network Number
CV: Use the IPX Routing: WAN Dialog Box.
TB:
Use configure and set the Numbered and Net keywords in the
IPX WAN 0 (and/or WAN 1) section.
Suggested for IPX
The settings above are all that is generally required for IPX operation
over Frame Relay.
•
AppleTalk Zone Name
CV: Use the AppleTalk Routing: WAN Dialog Box.
TB: Use configure and set the Numbered, NetLower, and DefZone
keywords in the AppleTalk WAN 0 (and/or WAN 1) section.
CV: Use the DECnet Routing Dialog Box (under Global/DECnet
Routing) and the DECnet: WAN Dialog Box.
TB: Use configure and set the Mode keyword in the DECnet WAN 0
(and/or WAN 1) section.
SMDS Configuration
This section covers the settings required for SMDS (Switched
Multi-megabit Data Service) operation of the MicroRouter 1200i WAN
0 interface (IP only). SMDS is a connectionless, packet-switched
service that offers LAN-to-LAN connectivity across a wide area at up to
1.544 Mbps.
v
Note:
The IP protocol settings and the physical communication
settings are the same as they would be for Frame Relay operation. The
only parameters which should be set differently for SMDS are the Link
Configuration and the SMDS addressing section.
