Compass Avantgarde 2019, Handbook

Page: 30 / 104

9-3
HOW TO USE YOUR CAMPERVAN’S EQUIPMENT
Water Level Calibration
Before the Water Level Button is used for the
first time, you will need to calibrate the
Control Panel to your water tank.
• Make sure your water tank is at the
recommended maximum level before
starting the calibration process.
• You will need to re-calibrate the Control
Panel if you change water tank.
Use the following steps to calibrate your
Control Panel.
1. Hold down both the Voltage Button and
Water Level Button for 6 to 8 seconds to
get into calibration mode.
2. When you are in calibration mode, the
Display Indictor will light up depending on
which water probe you ha\ve installed.
Pressure Probe
5-Prong Probe Resistive Probe
Vegas Voltmeter without Water or
Gas Level
Display Indicator
The Display indicator on the Vegas Voltmeter
Panel is used to display the Leisure Battery
voltage.
ïIf a waste tank is fitted, the lowest indicator
will illuminate when the waste tank is full.
3. To cancel calibration mode, press and
hold Leisure Battery Voltage Button for
two seconds.
4. To start the calibration process, press
and hold the Water Level Button for two
seconds.
5. If the calibration process was successful,
the display will flash three times.
• If the calibration process is
successful, the Control Panel will
restart and be ready to use.
6. If the calibration process was
unsuccessful, the display will flash two
times.
• If the calibration process fails, go
back to step 2 to start the calibratio
process again.
Leisure Battery Voltage Button
When the Leisure Battery Voltage Button is
pressed, the Display Indicator will light up
and display the voltage level of the Leisure
Battery. The button on the right of the panel
is not used on this panel.
Display
Indicator
Leisure
Battery
Voltage
Button
Button
not used