24
E
item 07 272
Nozzle settings
The nozzle has adjustable water jet from narrow to wide waterflow, for different types of cleaning. To
adjust the nozzle, proceed as follows:
1. Hold the tube by one hand
2. Turning the end of the spraying tube by other hand, as it will
change the type of waterflow.
Use a narrow flow to clean small areas, wide for large areas.
Total stop system
The machine is equipped with a full stop function that automatically shuts off the engine as you release the trig-
ger on the gun. If you press the trigger, the engine will start up again.
ATTENTION! -
Some varnished or treated surfaces may be sensitive to water jet damage from a high pressu-
re cleaner. Always make sure that you can use a high pressure cleaner on the surface before use. E.g. For
vehicles, refer to the vehicle documentation for the relevant information.
General principles of high pressure cleaning:
Never place the nozzle closer than 30 cm from the cleaned surface. Never use a water jet on peeling areas or
other non-standing surfaces or components. Always move the water pressure continuously, never let it work
longer on one place.
Turn on the machine
If the high-pressure cleaner is switched on and connected to the water supply,
it starts up by pressing the trigger on the pressure gun.
Turn off the machine
1. Move the rotary switch on the high-pressure cleaner to 0 - off position.
2. Switch off the water supply.
3. Press the trigger on the pressure gun to drain the pressurized water from the machine.
4. Secure the trigger with the sliding mechanism in the off position.
5. Disconnect the machine from the mains.
Installing the detergent dispenser
1. Make sure that the trigger is locked and that the machine is turned off.
2. Fill the container with appropriate, biodegradable
detergent for high pressure cleaning.
3. Put dispenser on the pressure gun, so that you disconnect the nozzle section
and put dispenser on the bayonet mechanism.
