0
10
20
30
40
1
Servo
Servo Nut
M2.5x16 Self
Tapping Bolt
2.5mm Washer
Standard Size
Rudder Servo
M2.5x16 Self Tapping
Bolt X 4
2.5mm Washer X 16
M2.5x8 Self-Tapping Bolt
Mini Servo
2.5mm Washer
Hole for
Mini Rudder Servo
Plastic Spacer
M2.5x10 Self Tapping Bolt
M2.5x8 Self Tapping
Bolt X 8
M2.5x10 Self Tapping
Bolt X 4
Plastic Spacer x 4
Servo Nut x 2
0
10
20
30
40
Use AB Glue
M3x10 Self Tapping Bolt
M3x5 Set Screw
2
Landing Gear
Landing Gear Struts
Skid Cap
Landing Gear Skid
A
B
M3 x10 Self Tapping
Bolt X 4
M3x5 Set Screw X 4
A
B
A
B
The 4 Plastic Spacers are used to
bring the Elevator Servo Arm in
Line with the Swashplate Link Ball.
Tip
:
Do not over tighten the four 3 x 5mm
set screws as it can damage the landing
struts.
The Servo installation is done without
the supplied Servo Rubbers.
The Swashplate Servos are installed
in between the 2 frames. The Self
Tapping Bolts are screwed from the
inside, while the Self Tapping Bolts
for the Rudder Servo are screwed
from the out side. The supplied Servo
Nuts are only used for the Rudder
Servo.
