Fibre Channel SAN Switch 2/16 Installation Guide
2–19
Installing the Fibre Channel SAN Switch 2/16
To configure Port Settings in a UNIX environment, type the following command,
tip /dev/ttyb -9600
7. Log onto the switch (with administrative privileges). The default administrative
logon is
admin
and the default password is
password
.
a.
Enter the following at the prompt:
ipAddrSet
b.
Enter the following information at the corresponding prompts, listed below:
—
Ethernet IP Address [
10.77.77.77
]:
Enter the new ethernet IP address.
—
Ethernet Subnetmask [
0.0.0.0
]:
Enter the new ethernet subnetmask.
—
Fibre Channel IP Address [none]:
Enter the new fibre channel IP address if desired.
—
Fibre Channel Subnetmask [none]:
Enter the new fibre channel subnet mask if desired.
—
Gateway Address [
172.17.1.1
]:
Enter the new gateway address.
—
Set IP address now? [y = set now, n = next
reboot]:
Enter “
y
” to set now.
c.
To verify that the IP address was entered correctly, type
ipAddrShow
d. Once the IP address is verified as correct, remove the serial cable, and replace
the shipping plug in the serial port.
CAUTION:
T
he serial port is intended only for use during the initial setting of
the IP address and for service purposes. Using the serial port during normal
switch operation or for regular maintenance is not recommended.
8. Record the IP address on the label affixed to the SAN Switch 2/16.
