2–8
Fibre Channel SAN Switch 2/16 Installation Guide
Installing the Fibre Channel SAN Switch 2/16
2. Locate three Phillips head, 8-32 x 3/16” screws provided in the Rack Mount Kit.
a.
Secure the Inner Slide Rail to the switch using the three Phillips head, 8-32 x
3/16” screws contained in the Rack Mount Kit, see Figure 2–2
b.
Tighten the screws and torque to 15-inch pounds..
Figure 2–2: Securing the Inner Slide Rails to the switch
3. Repeat steps 1 and 2 to attach the second Inner Slide Rail to the switch. Make sure
to orient the second Inner Slide Rail in the same way you positioned the first
(based on 1a or 1b above).
Attaching the Rear or Front Rack Mount Brackets
The Rack Mount Kit supplied with the SAN switch 2/16 contains two Rear Rack
Mount Brackets and two Front Rack Mount Brackets. Install these Rack Mount
Brackets to prevent the switch from accidentally sliding out of the rack, as follows.
IMPORTANT: Compaq recommends installing the SAN Switch 2/16 so that the port side of the
switch slides out the back of the 9000 Series Rack. (For example, the switch should face the
aisle where exhaust air is released. Air intake and exhaust for all components in the rack should
flow in the same direction.)
SHR-2477A
