Compaq Confidential – Need to Know Required
Writer: Carmen Wheatcroft Project: Compaq PowerStorm 600 Graphics Controller Hardware Guide Comments:
Part Number: 120259-XX1 File Name: d-ch3 Installing the Hardware.doc Last Saved On: 2/19/99 9:01 AM
Chapter
3
Installing/Removing the Hardware
Your Compaq PowerStorm 600 Graphics Controller was factory-installed by
Compaq Computer Corporation. The instructions in this chapter and Chapter
4 are provided for your reference.
Refer to your workstation reference guide for instructions on opening and
closing the workstation, identifying the AGP and PCI slots, and adding
expansion cards.
Before Installing or Removing the
Hardware
To start the installation:
1.
Confirm that power to the workstation and to the monitor is off.
Disconnect the power cord from the system and allow the power to
dissipate for 15-30 seconds before proceeding.
2.
Open the workstation to gain access to the AGP and PCI expansion
slots.