. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4-39
Netelligent 2008/2016 10Base-T Repeater User Guide
Writer:
Chris Seiter
Project:
Netelligent 2008/2016 10Base-T Repeater User Guide
Comments:
185814-003
File Name:
2000_4.doc
Last Saved On:
8/21/96 10:42 AM
■
late events
■
frame check sequence errors (FCS)
■
frame alignment errors
■
data rate mismatches
■
total errors
■
new last source address (0 if port never used)
■
last source address
■
source address changes
■
autopartitions
■
autopartition state (yes/no)
■
link test status
■
link state
■
port administration (enabled/disable)
■
port type
■
port operational status (yes/no/not available)
When you power off the repeater, the statistics listed above are cleared.
Traps
The Netelligent 2008 and 2016 repeaters support the following trap types:
■
Cold Start Trap
signifies that this repeater is reinitializing itself.
■
Authentication Failure Trap
signifies that this repeater has been
sent a protocol message that is not properly authenticated.
■
Novell Repeater MIB Traps
an enterprise specific trap defined by
the Novell Repeater MIB.