. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-3
Netelligent 2008/2016 10Base-T Repeater User Guide
Writer:
Chris Seiter
Project:
Netelligent 2008/2016 10Base-T Repeater User Guide
Comments:
185814-003
File Name:
2000_3.doc
Last Saved On:
7/15/96 11:37 AM
NOTES:
The MEP is the 17th logical port on the repeater.
Link test is available for the fiber optic AMC (hardware is always enabled, but
firmware can effectively disable link test), but not for the AUI or BNC AMCs.
AUI Connector
BNC Connector
(Thinnet)
Fiber Connector
(10BASE-FL)
Optional Alternate Media Connectors
Figure 3-3.
Optional Alternate Media Connectors
Setting Jumpers for a BNC AMC
If you install a BNC AMC, but do not connect a cable, you must set the
connector board jumper to disable the port. You can also use an external
terminator on this port. If you use a terminator, set the jumper to ON for
future connections.
NOTE:
If there is no connection or external terminator at the BNC port, the jumper
must be set to OFF; otherwise, excessive collisions will occur and adversely affect
network performance.
Figure 3-4 shows the AW1 jumper settings.