Compaq Evo D510 e-pc, Upgrade Manual

Page: 15 / 24

12 Upgrade Guide
Upgrading and Replacing Hardware
Configuring an IDE Device After Installation
After installing any device, you can check via the Summary Screen
that your e-pc has correctly identified the new configuration. To view
the Summary screen, restart the computer. When the Compaq logo is
displayed, press
F8,
then select Summary from the list of options.
If the configuration is not correct, run the Setup program to configure
the device. To enter the Setup program, To access Computer Setup,
restart the computer. When the Compaq logo is displayed, press
F8,
then select Setup from the list of options.
IDE drives are automatically detected by the Setup program.
However, a newly installed device may require that you install an
appropriate device driver. Refer to your operating system
documentation for details. You can obtain the latest drivers from the
support Web site at
http://www.compaq.com/support.
The IDE cables in your e-pc are cable select. You must, therefore, set
the jumpers on any IDE devices you install to cable select. See the
documentation for the device for more information.
305513-001.book Page 12 Tuesday, August 20, 2002 4:35 PM