Installation
2-11
Compaq Confidential – Need to Know Required
Writer:
Bob Young
Project:
Compaq StorageWorks SSL2000 Series Library Reference Guide
Comments:
Part Number:
187193-001
File Name:
c-ch2 Installation.doc
Last Saved On:
4/17/00 9:10 AM
Installing the Rackmount Model into a Storage
Cabinet
1.
With the inner slide members attached to the Library, install the middle
and outer slide members to the storage cabinet, following the installation
instructions in the
Compaq Rack Planning Guide
.
2.
Using two people, lift the Library and visually align the inner and
middle slide members. Carefully insert the Library’s inner slide
members into the extended middle slide members.
3.
Slide the Library completely into the storage cabinet until the front
panel touches it.
4.
Secure the front panel to the storage cabinet using the supplied screws
and cage nuts.
NOTE:
If you are installing a pass-through mechanism (used for multi-unit Library
systems), use the supplied “L” brackets (
4
Figure 2-6). These brackets are shipped in
the pass-through mechanism hardware kit or expansion kit. Install the brackets onto the
outer slide member at the location shown in Figure 2-6.
Setting up Interfaces and Cables
The following sections describe the cables required for each of the connectors
at the rear panel (see Figure 2-9 and Table 2-2).
Refer to Chapter 3, “Installing and Removing the Pass-Through Mechanism,”
for detailed information on how to connect cables to the PTM motor housing
assembly and Library units.
