I
NSTALLING
AN
HSG80
OR
HSZ80 A
RRAY
C
ONTROLLER
About This Card
Follow these instructions to replace either an HSG80 ACS Version 8.x
or an HSZ80 ACS Version 8.3 Array Controller.
NOTE:
For instructions on upgrading a single-controller configuration to a
dual-redundant controller configuration, see the appropriate
DIGITAL
StorageWorks
TM
HSG80 Array Controller ACS Version 8.2 User’s Guide,
Compaq
TM
StorageWorks HSG80 Array Controller Version 8.x Maintenance and
Service Guide
, or
Compaq StorageWorks HSZ80 Array Controller ACS Version 8.3
Maintenance and Service Guide
.
General Information
Figure 1, Figure 2, and Figure 3 provide general information about the
specific host cable connection for each array controller.
NOTE:
The maintenance port cable shipped with the HSG80 and HSZ80 array
controller has a 9-pin connector for a PC connection only. If using a terminal
instead of a PC, order the optional maintenance port cable from the local field
service office.
Figure 1. HSG80 array controller with optical GLM
TM
1
Backplane connectors
2
Access door
3
Optical gigabit link module
(GLM)
4
Program card slot
5
Program card ejection button
6
Program card
7
Program card electrostatic
discharge (ESD) cover
8
Fibre channel optical cables
9
Maintenance port cable for a
PC connection
-
Maintenance port
q
Operator control panel (OCP)
w
Release lever
Optional adapters for a terminal
connection (9-pin D-sub to 25-pin
D-sub, not shown):
■
Male to female (null modem),
part numbers:
173407–001 / 12–45238–01
■
Male to male (null modem),
part numbers:
173407–002 / 12–45238–02
■
Male to male (modem),
part numbers:
173407–003 / 12–45238–03
CXO7198A
1 2 3 4 5 6
1
6
4
5
3
2
8
11
9
10
12
7
European Union Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and
the Low Voltage Directive (73/23 EEC) issued by the Commission of the European
Community. Compliance with these directives implies conformity to the following
European Norms (in brackets are the equivalent international standards):
■
EN 55022 (CISPR 22)
Electromagnetic Interference
■
EN 50082-1 (IEC 801-2, IEC 801-3, IEC 801-4)
Electromagnetic Immunity
■
EN 60950 (IEC 950)
Product Safety
NOTICE
© 2000 Compaq Computer Corporation. Printed in the U.S.A.
COMPAQ, Compaq logo, and StorageWorks Reg. U.S. Pat. & Tm. Off. Windows NT is a
trademark of Microsoft Corporation. All other product names mentioned herein may
be trademarks or registered trademarks of their respective companies.
The information in this publication is subject to change without notice and is provided
“AS IS” WITHOUT WARRANTY OF ANY KIND. THE ENTIRE RISK ARISING OUT OF THE
USE OF THIS INFORMATION REMAINS WITH RECIPIENT. IN NO EVENT SHALL COMPAQ
BE LIABLE FOR ANY DIRECT, CONSEQUENTIAL, INCIDENTIAL, SPECIAL, PUNITIVE OR
OTHER DAMAGES WHATSOEVER (INCLUDING WITHOUT LIMITATION, DAMAGES FOR
LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION OR LOSS OF BUSINESS
INFORMATION), EVEN IF COMPAQ HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES. THE FOREGOING SHALL APPLY REGARDLESS OF THE NEGLIGENCE OR
OTHER FAULT OF EITHER PARTY AND REGARDLESS OF WHETHER SUCH LIABILITY
SOUNDS IN CONTRACT, NEGLIGENCE, TORT, OR ANY OTHER THEORY OF LEGAL
LIABILITY, AND NOTWITHSTANDING ANY FAILURE OF ESSENTIAL PURPOSE OF ANY
LIMITED REMEDY.
The limited warranties for Compaq products are exclusively set forth in the
documentation accompanying such products. Nothing herein should be construed as
constituting a further or additional warranty.
INSTALLING AN HSG80 OR HSZ80 ARRAY CONTROLLER
Third Edition (February 2000)
Part Number: EK–80CTL–IN. F01
Compaq Computer Corporation
