4
O-ring
1
2
3
4
ASSEMBLY
Shower stand consists of two parts – Base and Shower Head Section.
TO ASSEMBLE
Step 1.
Locate a suitable solid and level surface.
Step 2.
Fold out legs until they lock in position. Loosen lock nut and
slide water inlet upwards then retighten lock nut. (Fig.1)
Step 3.
Check that the rubber “O” ring is located in the brass fitting
on the base of the shower head section before attaching to
the water flow control – take care not to cross thread the
connection. (Fig.2)
Step 4.
Holding the shower head section firmly, position on the thread
of the flow control and rotate the brass nut in a clockwise
direction until tight – take care not to over tighten. (Fig.3)
Step 5.
To extend shower head section, hold and loosen the height
adjusting nut in an anti-clockwise direction, slide the shower
head upwards until the desired height is reached then
retighten the nut in a clockwise direction. (Fig.4)
