COMPANION 315.101860, Operator'S Manual

Page: 7 / 18

7
KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
WARNING:
Carefully read through this entire
operator's manual before using your new drill-driver.
Pay close attention to all Safety Rules, Warnings and
Cautions. If you use your drill-driver properly and
only for what it is intended, you will enjoy years of
safe, reliable service.
WARNING:
Do not allow familiarity with your drill-
driver to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
KEYLESS CHUCK
Your drill-driver has a keyless chuck that allows you to hand
tighten or release drill bit in the chuck jaws.
DIRECTION OF ROTATION SELECTOR
FORWARD/REVERSE
Your drill-driver has a forward/reverse selector located
above the switch trigger. The switch trigger can be locked
in the
OFF position.
SWITCH TRIGGER
To turn your drill-driver ON , depress the switch trigger.
Release switch trigger to turn your drill-driver OFF .
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
BIT STORAGE
When not in use, bits provided with your drill-driver can be
placed in the storage area located on the top of the motor
housing.
TORQUE ADJUSTMENT RING
Your drill is equipped with an adjustable torque ring for
driving different types of screws into different materials.
The proper setting depends on the type of material and
the size of the screw you are using.
FEATURES
Chuck ........................................... 3/8 in. (10 mm) Keyless
Motor .............................................................. 14.4 Volt DC
Switch ....................................................... Variable Speed
Gear Train ............................................................. 1 Speed
No Load Speed ................................................. 0-650/min.
Clutch ............................................................... 4 Positions
Charger Input ................................. 120 V. 60 Hz, AC only
Charge Rate ....................................................... 3-6 Hours
Torque .................................................................... 90 in.lb.
PRODUCT SPECIFICATIONS