2.LIGHTING BURNER
1. Check that the gas
control is shut off, then
turn the gas cylinder
valve on in an anti-
clockwise direction
for one full turn.
2. Take a lit match or
lighter and position
close to the edge of
the burner that is to
be ignited, slowly
turn the gas control
in an anti-clockwise
direction approximately
¼ of a turn.
3. If the burner does
not ignite, turn the
gas control in the
clockwise direction
to the “Off” position and allow the
residual gas to disperse before
attempting to reignite the burner.
3.ADJUSTING FLAME
1. Turn the gas control
in an anti-clockwise
direction to achieve
a higher flame and in
the clockwise direction
for a lower flame.
4. TURNING THE APPLIANCE OFF
If the appliance is no longer to be used and to reduce the
risk of blocked gas jets caused by excess gas being left in
the hose, all remaining
gas must be expelled
from the hose assembly.
1. With the flame still
operating, turn
the valve on the
gas cylinder in the
clockwise direction
until it is “Off”. Allow
the flame to burn
down then extinguish
once all remaining
gas in the hose has
been used.
2. Turn the gas controls
on the appliance
clockwise to the
“Off” position.
CARE INSTRUCTIONS
Your appliance is manufactured with a hard wearing powder
coated finish on the cabinet, chrome plated burners, trivet
and stainless steel drip tray (if fitted) and is easy to clean.
Using warm soapy water with a mild detergent wipe down
all surfaces and areas of the appliance, taking care not
to allow water to enter the burner outlets or aeration holes
located in the burner tube.
DO NOT
submerge the appliance is a sink or bowl.
DO NOT
use abrasive cleaners or bleach.