13
OPERATION
PREPARING TO WORK
1.
Prepare the machine for operation
2.
Check that suction unit switch (1) is set to ”ON” and make sure the paper filter is
installed.
3.
Sit in the driver’s seat
4.
Check that the parking brake is released (1)
5.
Turn main switch key (3) clockwise to “1”. Display (4) on the dashboard will immediately
turn on and indicate the level of the battery charge and the hour counter.
1 2
6.
Press base lift-lower switch (5) down to lower the base; press polishing pad switch (6)
(green signal lamp on).
5
6
7.
Select forward speed turning knob (7). The selector has three positions, indicated by
symbols: turtle = slow speed, middle position = normal speed, rabbit = fast speed
8.
Select the drive direction on switch (8)
9.
The machine starts to move when you press accelerator pedal (9). The base will start to
lower and the polishing pad will start to rotate when it is totally lowered down (the base
lifts up a few centimeters and the pad stops when the accelerator pedal is released)
10.
Check work quality during the first few meters of work.
Whenever problems arise during operation turn off key (1), quickly detach emergency
lever (2) placed below the operator and set the emergency brake by pushing lever (3)
down and pulling it towards yourself until it hooks up.
These procedures will block all
machine movements. To start working again, after you have solved the problem, reconnect
connector (2), turn key (1) and release parking brake lever (3).
The machine will not move if the operator is not firmly seated on the seat.
2
3
7
8
9
3
4
1
