INS_CNFE2DOE2_REV–
10/11/11 PAGE 11
INSTALLATION AND OPERATION MANUAL
CNFE2DOE2
TECH SUPPORT: 1.888.678.9427
Using Terminal Server as a Serial Extender over Ethernet
To use the Terminal Server as a serial extender over Ethernet, connect two terminal servers to your
local Ethernet network.
Configure the first device as a server:
»
Set port 1 to
Server
Network Mode. Assuming Port 1 will be used, click on the
Port 1 Settings
on the left.
»
Configure data type and data rate on
Configurations
page. Click
Save
.
Port 1 Settings Page in Server Mode
Repeat above steps to configure second device. Change its IP address to
192.168.12.2
.
Assuming Port 1 is used, click
Port 1 Settings
on the left side of the screen.
Configure the device to be client:
»
Set Port 1 Settings to
Client
Network Mode.
»
Configure data type and data rate on
Configurations
page. Click
Save
.
