Page 11
R.5-MAX, R2-MAX, R6-MAX
Installation and Operation Manual
(2) 1/2"-13 Weld nuts
(Located at CL of top and
bottom drivers on the back of
the horn)
(2) 1/2"-13 Weld nuts (Typical
top and bottom)
(2) Mounting points on
back of horn
Center of Gravity
(not a suspension point)
Center of Gravity
(not a suspension point)
TOP VIEW
SIDE VIEW
FRONT VIEW
24"
(610)
34.5"
(876)
36"
(914)
37"
(940)
49"
(1245)
24.5"
(622)
43.5"
(1105)
12.75"
(324)
12.75"
(324)
0.75"
(19)
3" (76) TYP
3" (76) TYP
0.313" (8) Dia.
Holes
MOUNTING POINTS
The cabinet should be mounted using at least 2-3 of the
primary mounting points shown below.
Note:
Dimensions are Identical for all R6 Models
Note:
Cabinets are handmade and measurements may vary
slightly due to the thickness of the fiberglass. Dimensions
shown should not be used to fabricate hanging fixtures.
Mounting points are approximate.
CONNECTING THE LOUDSPEAKER
Each R6-MAX model has 12 ft (3.6m)
16-2 SJOW cable(s) attached to the
enclosure with a weathertight gland
nut (one for the R6-BHMAX and
three for the R6-51MAX - LF/MF/HF).
These cables may be connected to
the amplifier’s speaker cabling using
solder, a terminal block, crimped
connections, or wire-nuts. Any
outdoor connections should be
protected with a weather-resistant
treatment (junction box or dielectric
compound). In all cases, do not
remove the gland nut attaching the
cable to the rear of the loudspeaker,
as this will compromise the weather
integrity of the enclosure.
