Page 8
Installation and Operation Manual
R.15COAX, R.35COAX, R.35-3896
Figure 6.
Weather cover attachment
(R.15 shown)
1+
1–
2+
2–
+
–
from
Amplifier
NL4-Type Connector
Figure 5a.
R.15 input panel
Figure 5b.
R.35 input panel
Terminal
Strip
Wattage
Selector
Switch
NL4
Music/
Voice
Switch
Must remove jumper, or move it to the bottom
terminals, for 8Ω operation (see arrow below)
Music /
Voice
Switch
Terminal Strip
Follow label to
determine
correct (+)
terminal
connection
NL4
Weather Cover,
Gasket (internal)
Gland Nut
(Barrel)
Pan Head
Screws
Input panel
Wire
INPUT PANEL CONNECTIONS
R
.15:
The connectors are wired in parallel. If utilizing the
NL4-type connector, refer to the detail inset. If utilizing
the weather cover, insert the cable end through the gland
nut and weather cover, and wire the terminal strip. Set the
Music/Voice and Voltage selector switches according to
your application (see
Figure 5a
).
FINAL ASSEMBLY AND TESTING
__Secure the gland nut to the weather cover. Align
the weather cover with the holes and attach using
the provided pan head screws. See Figure 6.
__All provided hardware (or other approved
replacement) must be installed in order to maintain
weather-resistance and preserve the product
warranty.
__Power and test the system.
R.35:
Insert the cable through the gland nut and weather cover and wire
the unit referencing the label for connections for your system voltage.
See
Figure 5b
. There is a preinstalled jumper that should be left in the
marked position for 70/100V use, or moved to the bottom terminals for
8Ω operation.
Failure to do so can result in damage to the loudspeaker
and/or amplifier.
Set the Music/Voice switch to the desired position
based upon your type of application.
The NL4 connection can only be
used for low impedance 8Ω operation.