Page 5
Installation and Operation Manual
R.15COAX, R.35COAX, R.35-3896
Figure 2b.
Orient the R.35 yoke correctly
R.35 Yoke
Orient angled
side to the
rear of the
loudspeaker
Use holes aligned with large
center hole as primary mounting
points - these are aligned
with the center of gravity.
Use other holes as secondary
reinforcement.
Figure 2a.
Orient the R.15 yoke
Mount using holes in the
yoke. Large hole in center
notes center of gravity
when loudspeaker is
suspended from above.
R.15 Yoke
INSTALLATION
BEFORE YOU START
__Read all instructions and gather tools necessary before starting the installation.
Please read all safety instructions and warnings regarding rigging and installation of
the loudspeaker. The "_" preceding each step can be used to check off each step as it is
completed (or applicable).
Every effort has been made to ensure that the information contained in this manual was
complete and accurate at the time of printing. However, due to ongoing technical advances,
changes or modifications may have occurred that are not covered in this publication.
The latest version of this manual is always available at www.communitypro.com. The
revision date can be found on the rear cover.
MOUNT THE LOUDSPEAKER YOKE
Attach the yoke to the support structure
prior to mounting the loudspeaker enclosure.
Community offers several pole mount kits to
facilitate mounting loudspeakers to poles.
Follow instructions included with those items
for proper installation of the loudspeaker.
__
Determine the appropriate location and
mount the yoke to the support structure
using properly rated, corrosion-resistant
fasteners. For mounting to a round pole, use
a properly rated mounting system.
Mounting
hardware is not included and should be
specified by a structural engineer.
For the R.35 models, ensure that the wider
angled portion of the yoke will be at the rear of
the loudspeaker when in the vertical position,
or toward the bottom of the enclosure in the
horizontal position. Always use the holes in
line with the larger center hole as the primary
mounting points. See
Figures 2a
(R.15) and 2b
(R.35) for yoke orientations.
A
dditional yokes for pan/tilt and down-
firing mounting options are available (see
Accessories section). Custom brackets may
be used, but must be approved by a structural
engineer and rated for the expected load.