- 20 -
Connecting a cellular telephone to the ICRI-2P
When connecting to a cellular telephone using the interface cable, P/N 179.0693, insert the 2.5mm
(1/16”) plug into the headset jack on the cellular telephone.
Be sure it is fully pushed into the
telephone’s jack; See FIGURE 20.
Set cell phone’s speaker/earphone audio to a mid-level setting following the cell phone
manufacturer's instructions.
The cell phone should be in the "auto answer" mode. See phone's instruction manual for the
procedure.
Dial a remote telephone or wait for an incoming call from another telephone.
To receive an incoming call, the phone must be set to auto answer, or an individual must be available
to answer the phone by pressing SEND or equivalent.
FIGURE 20: ICRI-2P CONNECTED TO CELL PHONE
FIGURE 21: RJ-10 CABLE FOR NOKIA™
