- 18 -
Setting radios to “bridge” through the ICRI-2P
Set the volume control on each connected radios to mid position between fully CLOCKWISE and
fully COUNTER-CLOCKWISE.
Set each radio to the desired channel.
NOTE:
The radios must not be on the same channel/frequency.
NOTE
: If the radios are in the same band (eg: VHF or UHF or 800MHz) considerable separation of
the radios will be necessary to minimize “desensing” the radio receive functions. Desensing will
cause radios to have their “range” severely limited.
NOTE:
Because the ICRI is connected to the radio via the speaker jack, the audio path on the
attached radio is disrupted. You will be unable to hear or speak through that radio. If you can hear
or talk through the radio, the cable may not be properly attached to your radio.
The LED directly beside the radio interface jack will light as audio is transmitted from the radio
through the ICRI.
Troubleshooting radio setup
NOTE: See Interoperability DO’s and DONT’S in Appendix E.
1. Verify the radio can function normally with a speaker-mic attached.
2. Verify the radio has a charged battery.
3. Verify to the interconnect cable is firmly connected to the radio and the ICRI.
The ICRI use locking ring to secure the connector, use the radio connector locking mechanism if
provided
