Com m Sk y
WLAN AP Quick Installation Guide
3.5 Connecting the power supply
AP 4600 series products support IEEE 802.3at PoE, supplying power over Ethernet. Customer can
select method of supplying power appropriate to the target network.
Prior to powering up, please ensure that there is a stable supply of power delivered to the equipment.
Regardless of using public utilities, UPS, or private generators, CommSky recommends to centralize
power supplied to the equipment. Such a power network is simple to use, safe to operate, flexibly
configured, and easy to maintain.
The low-voltage power supply uses a single-phase three-wire system.
3.5.1 Pre-power-up checklist
After AP is installed, please verify each of the following items prior to powering up:
If AP uses local power supply, make sure supply has a good connection to the power source.
If AP uses PoE power supply, make sure PoE supply has a good connection to power source
3.5.2 Local power supply
NOTE
Power adapter, and power cable are user-supplied.
Table 1 Power adapter specifications
Item
Description
Input
100 VAC to 240 VAC
Output
+48V --- 0.8A
The AP 4600 supports both AC and DC power adapters. You can connect the power port of the AP
to the power source through a power adapter to supply power to the AP.
Figure 7 Local power supply connection
3.5.3 PoE power supply
If uplink device of an AP is a PoE switch, then use an Ethernet cable to directly connect Ethernet
interface on the AP to the PoE device.
9 CommSky Technologies, Corp.
