Page 7 of 10
© 2019 CommScope, Inc. All Rights Reserved
6.4.7
Route the fibers trough the slit to the splice area of
tray 2.
6.4.8
Clean the fibers and make fusion splice. Store the
splice protectors and the fiber overlength properly.
6.4.9
In case fiber length may not fit perfectly excess
length can be pulled back to the top of the tray where ad-
justment in storage length can be done. (Small islands can
be used). Uncut fibers can also be stored in this zone using
the figure 8.
6.4.10
Close properly (snap feature in cavity).
6.4.3
Guide the bundle over the top with the 2nd ktu.
The ktu’s can be stacked.
6.4.4
Route the bundle trough the slit towards the top
area of tray 2.
6.4.5
Remove the jacket in the middle of the tray.
6.4.6
Clean fibers and route as follows: 1 bundle should
go via figure 8. The 2nd bundle can go directly.
KTU
