If the cable is not positioned freely, remove the two port reducers.
Rear
1
2
1 Lift up the two port reducers at the both sides of the Octopus
™
gel seal (no tools needed).
2 Remove both parts.
8.2.2
Install feeder cable
Feeder out (F2)
Feeder in (F1)
1
1
2
2
1 Install the feeder cable (with the strain relief bracket installed) into the organizer. A loop feeder cable will typically
be installed one end left (F2 - feeder out) and one end right (F1 - feeder in).
2 The bracket snaps in the interface plate of the organizer.
page 12 / 24
© 2021 CommScope, Inc. All Rights Reserved
