CommScope M2400 Series Instructions Manual Download

Page: 3 / 7

www.commscope.com

860481019

Issue 4, November 2012

Page 3 of 7

Install Panel on Rack

Align slots
in panel
with screws

Slide panel to right
to engage screws

12-24 x 1/2”
screw

1. Position panel against rack rails offset to the left of the partially installed screws.

2. Align slots in panel with screws and slide panel to right to engage screws.

Secure Panel to Rack

holes in panel

Use a screwdriver to access screws through holes in panel. Tighten screws to secure panel to rack.

Summary of Contents for M2400 Series

Page 3: ...t to engage screws 12 24 x 1 2 screw 1 Position panel against rack rails offset to the left of the partially installed screws 2 Align slots in panel with screws and slide panel to right to engage screws Secure Panel to Rack holes in panel 1 Use a screwdriver to access screws through holes in panel Tighten screws to secure panel to rack ...

Page 4: ... Snap end caps into place on panel as shown Step 1B M2400A Angled Panel Installation Install Panel on Rack 12 24 x screws 19 inch equipment rack M2400A panel 12 24 x screws 1 Use four supplied 12 24 x screws to secure panel to rack 2 Connect cables to outlets per instructions provided with the individual outlets ...

Page 6: ...bels for port designation Icons 1 Apply labels and icons to front of panel as shown for port designation Step 5 Using Module Removal Tool Part of Removal Tool Kit 760122713 To Remove End Cap Insert tool into slot Slot End cap 1 Insert provided tool into slot as shown 2 Use tool to pry end cap loose from panel ...

Page 7: ...tool 1 Position tool as shown and insert into front of outlet to depress locking tabs 2 Remove outlet from rear of panel To Remove Modular Cap Insert end of tool into slot under cap Slot Pivot tool forward to disengage cap 1 Insert tool into slot as shown and pivot forward to disengage modular cap for removal from outlet ...