ADCP-93-095 • Rev B • April 2018
Page 10
© 2018, CommScope, Inc.
Figure 7. Installing the Connector Module (23-Inch Rack Shown)
1. Determine the mounting location and rack width, and reposition the mounting brackets if
required:
a. If installing the panel on a 19-inch rack, remove the two mounting brackets and re-
install them using the 19-inch orientation (refer to
b. If installing the panel on a 23-inch rack, install the chassis with the mounting brackets
positioned as shipped.
2. Secure the mounting brackets to the rack front flange using six #12-24 mounting screws.
5.2
Grounding an Armored Cable
When installing an armored cable, a procedure is required, before breaking out the cable, to
sever and ground the armor. A CommScope kit is available for grounding the armor (catalog #
GND-STPKIT). For details, refer to the instructions shipped with the kit (ADCP-90-382).
Note:
If jumper retainers are present on the rack, remove the jumper retainers and reinstall
them with the chassis as shown in
. The jumper retainers may be either LGX or
the CommScope equivalent product.
LGX JUMPER
RETAINER
266
3
7-A
MOUNTING
BRACKET
RACK FRONT
FLANGE
12-24X
S
CREW (6)
LGX JUMPER
RETAINER
