D701-0006
www.commscope.com
© 2016 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. D701-0006 D (10/16) Page 2 of 7
Installation Instructions
Ensure a torque spanner is used when tightening fasteners, see the mounting kit
diagrams on the following pages for the correct torque recommendations.
Ensure antenna is installed with the connectors and drainage holes at the bottom.
Installation Instructions - Fixed Downtilt Mounting Kit (F-042-GL-E)
Assemble both mounting brackets to the antenna as per Figures 1, 2 & 3 of this document.
Attach the mounting kit assembly to the antenna, before trying to clamp the brackets
to the pole.
The clamp brackets can clamp pipe diameters between 75 mm (3") & 115 mm (4.5").
For typical installations the minimum recommended pipe diameter is 85 mm (3.3").
Figure 1. Correctly Assembled
Mounting Brackets for
Fixed Downtilt Antenna
Do not install near power lines. Power lines,
telephone lines, and guy wires look the same.
Assume any wire or line can electrocute you.
Do not install on a wet or windy day or
when lightning or thunder is in the area.
Do not use metal ladder.
Wear shoes with rubber soles and heels.
Wear protective clothing including a
long-sleeved shirt and rubber gloves.
