CommScope 3RU FPX, Installation Instructions Manual

Page: 17 / 34

TECP-92-160 • Rev C • May 2018
Page 17
© 2018 CommScope . All Rights Reserved.
Figure 17. Stacked Cable Clamps
3.6 Preparing and Connecting a Pre-Connectorized Cable Assembly
This section tells how to how to prepare and connect a pre-connectorized cable assembly. The
cable being installed must conform to the breakout dimensions provided.
Use the following procedure.
1. If the cable is being connectorized, assure it conforms to the breakout shown in
Figure 18
,
Figure 19 , or Figure 20 for the cable type identified. For ‘L’ dimensions, refer to Table 2 .
Figure 18. IFC Stranded Cable Breakout Dimensions
Table 2. Breakout Dimensions
CABLE TYPE FIGURE L2 L3 L4 L5
IFC Stranded Figure 18 3RU 63.0 in
(160.0 cm) 37.0 in
(93.1 cm) N/A 67.75 in
(172.1 cm)
Figure 18 4RU 64.5 in
(163.8 cm) 37.0 in
(93.1 cm) N/A 69.25 in
(175.1 cm)
Figure 18 5RU 65.5 in
(166.4 cm) 37.0 in
(93.1 cm) N/A 70.25 in
(178.4 cm)
YOKE S (4)
GROMMET S (2)
S CREW S (2)
PLATE
25715-A
O S P/IFC
CABLE
FANOUT LENGTH
‘L 3 ’ +0.0 IN./-6.0 IN.
(+0.0 CM/-15.2 CM)
BREAKOUT LENGTH
‘L2’ +0.0 IN./-6.0 IN.(+0.0 CM/-15.2 CM)
MULTIFIBER
S UBUNIT S
CONNECTOR S
HEAT S HRINK
6.0 IN. (15.2 CM)
CLAMP
25717-A
CLAMP PO S ITION
‘L5’ +0.0 IN./-6.0 IN.(+0.0 CM/-15.2 CM)