CommScope 3RU FPX, Installation Instructions Manual

Page: 18 / 34

TECP-92-160 • Rev C • May 2018
Page 18
© 2018 CommScope . All Rights Reserved.
Figure 19. IFC Ribbon Breakout Dimensions
2. Determine the correct clamp and grommet combination required to secure the cable to the
panel. For details on the cable clamp itself, refer to Section 3.5 on Page 16 .
3. Determine the cable entry location. Cables may enter the panel from either top or bottom
and may be clamped to either the left or right side, top or bottom, as shown in Figure 21 ,
Figure 22 , Figure 23 , and Figure 24 . Use the integral fanning tree to arrange the fibers so
that they are across from the adapter where they are being terminated.
IFC Ribbon Figure 19 3RU 64.8 in
(164.6 cm) 38.5 in
(97.8 cm) 24.5 in
(62.2 cm) 70.0 in
(177.8 cm)
Figure 19 4RU 65.8 in
(167,1 cm) 38.5 in
(97.8 cm) 25.5 in
(64.7 cm) 71.0 in
(180.3 cm)
Figure 19 5RU 66.8 in
(169.7 cm) 38.5 in
(97.8 cm) 26.5 in
(67.3 cm) 72.0 in
(182.9 cm)
OSP Cable
(Stranded
or Ribbon) Figure 20 3RU 64.6 in
(164.1 cm) 38.5 in
(97.8 cm) 25.3 in
(64.3 cm) 68.0 in
(172.7 cm)
Figure 20 4RU 65.6 in
(166.6 cm) 38.5 in
(97.8 cm) 26.3 in
(66.8 cm) 69.0 in
(175.3 cm)
Figure 20 5RU 66.6 in
(169.2 cm) 38.5 in
(97.8 cm) 27.3 in
(69.3 cm) 70.0 in
(177.8 cm)
Table 2. Breakout Dimensions, continued
CABLE TYPE FIGURE L2 L3 L4 L5
25718-A
S UBUNIT
DE S IGNATION
LABEL
CONNECTOR S
CLAMP
INDIVIDUAL
PROTECTIVE
TUBING
INDIVIDUAL
UPJACKETED
FIBER
FLARE
TUBE
FANOUT
BREAKOUT LENGTH
‘L2’ +0.0 IN./-6.0 IN.(+0.0 CM/-15.2 CM)
CLAMP PO S ITION
‘L5’ +0.0 IN./-6.0 IN.(+0.0 CM/-15.2 CM)
FANOUT LENGTH
‘L 3 ’ +0.0 IN./-6.0 IN.
(+0.0 CM/-15.2 CM)
‘L4’ +0.0 IN./-0.5 IN.
(+0.0 CM/-1.27 CM)