7 HOMEDEPOT.com
Please contact 1-877-527-0313 for further assistance.
Installation (continued)
5
Installing the LED strip
□
4A Tape method: Working from one end to the other, remove the 3M paper backing and press into place.
Press between the LEDs to help ensure secure contact with the mounting surface. Avoid pressing on the
individual LEDs as this could damage the LED solder connections.
□
4B Clip and screw method: Place the LED strip in the desired position. Use the clips and screws to secure
the LED strip as shown. Clips should be placed in open areas of the strip. Do not cover the LED lights.
□
Plug the adapter into the wall receptacle and then use the remote to turn the LEDs on.
4A
4B
NOTE:
a.
b.
c.
LED Chip
Correct
lncorrect
lncorrect
Angle ≥ 90°
Angle ≥ 60°
a≥60°
a<60°
a. Use an angle greater or equal to 90 degrees when there is an LED chip on the corner while placing the strip in a concave position.
(Angle≥90°)
b. Use an angle greater or equal to 60 degrees when there is no LED chip on the corner while placing the strip in a concave position.
(Angle≥60°)
c. Use an angle greater or equal to 60 degrees when there is an LED chip on the corner while placing the strip in a convex position.
(Angle≥60°) In the convex position the angle should not reach 90 degrees. See above diagram.
