6
Junction Box Installation (continued)
3
Connecting the back-up
battery
□
Connect the PCB board connector to the
battery connector.
NOTE:
The battery will take 24 hours to fully charge.
4
Assembling the fixture
□
Align the locking tabs and push the housing (A)
directly onto the backplate (B).
□
Restore power to the fixture. The Test switch (C)
should illuminate.
A
B
C
Conduit Installation
1
Mounting and wiring the
fixture
WARNING:
USE FLEXIBLE CONDUIT ONLY
This product must be installed in accordance with
the applicable building codes, electric codes, and
ordinances. Be sure to comply with your local and
state regulations. It is recommended that this product
be installed by a licensed electrician or by qualified
service personnel.
□
Route the wires through the hole in the conduit
flange (1a) or through the rear of the backplate
(B) (1b) and make the conduit connection in
accordance with code requirements.
□
For 120 V applications, use the black and white
wires. Connect the black supply wire to the
black fixture wire. Connect the white supply
wire to the white fixture wire.
□
For 277 V applications, use the red and white
wires. Connect the red supply wire to the red
fixture wire. Connect the white supply wire to
the white fixture wire.
□
Using the backplate (B) as a template, mark
and drill two installation holes on the wall at
the desired installation location.
□
Insert wall anchors (CC) into the holes.
□
Attach the backplate (B) to the wall by
inserting screws (AA) through the backplate (B)
and into the wall anchors (CC).
B
BB
E
B
CC
AA
1a
1b
